Some Strut Mounts have adjustable “clock” position insulators
During installation, what sometimes appears to be a mis-positioned welded spring seat may actually be caused by the need to reposition the upper mount rubber insulator. To install some struts, it may be necessary to rotate the upper strut mount insulator, which can be separated from the mount. The directions are as follows:
Make a mark on the upper mount in line with (depending on the model) the notch in the strut pinch bolt area or the steering knuckle bracket.
- Disassemble and loosen the spring compressor to remove the mount and insulator.
- Separate the rubber insulator from the underside of the mount, then place the insulator back on the spring so it matches the spring’s position.
- Put the strut back into the spring and put the mount onto the insulator.
- Align the mark on the mount to the notch in the strut or steering knuckle bracket.
- Compress the mount and spring assembly, install and torque the strut nut to OEM specifications.
- Reinstall the assembly.
Categories
Replacement shocks and struts may be different lengths than the OE units. In some instances, a unit may be longer…
Most shocks and struts come with loose parts, including nuts, washers, spacers, and possibly a bumper. Before installing the shocks…
To ensure the vehicle performs safely and as designed, always replace in pairs. When damping rates differ significantly from side…
Mounting stud lengths may differ slightly, but all should mount correctly. The most common difficulty occurs when trying to install…
Using an air or electric impact wrench to tighten the upper mounting nut on the piston rod can exceed the…